search

Vitec Multimedia HDM950 Guía de usuario Pagina 48

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 70
  • Tabla de contenidos
  • MARCADORES
    • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 47
CONFIDENTIAL – This document is property of VITEC MULTIMEDIA, and may not be used or diffused to a third party without prior written approval.
LW Player User Guide v2.6 page 48 / 70
7.8. Genlock
Set Up Genlock
- Plug SAC012 cable to the middle pins of J4 connector on the master board. The middle pins
provide Y-component signal, which can be used for genlocking of a slave board.
- Plug the cable to J1 connector of the slave board.
- If there is a next slave board use JP2 connector of the genlocked board to pass through the
genlock signal.
- Plug a 75Ohm terminator to JP2 of the last board in the chain.
- Open PlayerLWm application.
- Select configuration of the slave board.
- Open [PLAYER CONFIGURATION]
- Choose [Edit Configuration]
- Expand [Device] in LW Setting Page.
- Expand [Genlock Control Settings].
- Set Clock Reference to Genlock Input.
- Close LW Setting Page.
- Choose configuration of the other slave board in the list Preview Window (page 33 (3)).
Repeat setting procedure for the board.
- When the boards are configured restart the PlayerLWm application.
Set Up SDI Synchronisation
SDI-Input of the board can be used to synchronize the board by external SDI signal.
It requires when the HD-SDI OUTPUT is set to 3G modes (1080p50/59.94 or 60).
- Plug SDI cable to HD-SDI output of the Master board.
- Plug the SDI cable to SDI input of the Slave board.
- Select configuration of the slave board in Preview Window.
- Open [PLAYER CONFIGURATION]
- Choose [Edit Configuration]
- Expand [Device] in LW Setting Page.
- Expand [Genlock Control Settings].
- Set Clock Reference to SDI Input.
- Close LW Setting Page.
Use SDI repeater to synchronize more than one slave board.
- Plug HD-SDI output of the Master board to SDI-IN of the repeater.
- Use the outputs of the repeater to synchronize the slave boards.
- Configure Clock Reference of every slave board to SDI-Input.
Check Genlock Status
Vista de pagina 47
1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 69 70

Comentarios a estos manuales

Sin comentarios
  • Hobby Zone Aircommand Bluelab HornetTek Lg-motorsports
  • Philips Las Unidades Flash Usb Milwaukee Martillos perforadores Gardena Accesorios De La Manguera De Agua ION Teclados JBL Amplificadores de audio de coche
  • Sony CMT-G1BIP Leonard LBN1310X Edimax IC-3030 Panasonic SCPM500
  • HP 2311x 23-inch Diagonal LED Monitor Manual de usuario Dell 4210X Projector Manual de usuario Brother HL-631 Guía de usuario INSTEON 2444-422 Manual de usuario